Emission (Chimney) Measurements
Sampling and analyzing the pollutants formed by the production and fuel use depending on the activities of various facilities and thrown into the atmosphere are defined as Emission Measurements. Emission Measurements are tested according to the parameters specified in the relevant standards and regulations and their compliance with environmental legislation is determined.
Within the scope of the Regulation on Control of Industrial Air Pollution, emission measurements in chimneys should be made at certain periods and planned measurements should be made. Some of the parameters to be Emission Measurements are as follows:
- TSE CEN/TS 13649 - Fixed Source Emissions - Determination of the mass concentration of each gaseous organic compound - Sampling tube (Active Carbon) and Solvent Desorption Method
- TS ISO 9096 - Fixed Source Emissions - Determination of Mass Concentration of Particulate Matter
- TS EN 13284-1 - Fixed Source Emissions-Determination of Low Range Mass Concentration of Dust
- EPA Method 17 - Fixed Source Emissions-Determination of Dust Emission Amount by In-flue Sampling
- EPA Method 5 - Fixed Source Emissions-Determination of Dust Emission Amount by Non-Chimney Sampling
- TS 9503 - Fixed Source Emissions-Determination of Smoke Density (Sootiness)
- EPA CTM 022 - Fixed Source Emissions-Determination of Nitrogen Monoxide (NO), Nitrogen Dioxide (NO2) and Nitrogen Oxide (NOx) Emissions
- TS ISO 12039 - Fixed Source Emissions-Determination of Oxygen (O2) Mass Concentrations
- TS ISO 12039 - Fixed Source Emissions - Determination of Carbon Monoxide (CO) and Carbon Dioxide (CO2) Mass Concentrations
- TS ISO 7935 - Fixed Source Emissions-Determination of Sulfur Dioxide (SO2) Mass Concentration
- EPA Method 4 - Fixed Source Emissions - Determination of Moisture in Flue Gas
- In-house method - "EM.SOP.05" - Fixed Source Emissions - Moisture Determination with Moisture Probe
- TS ISO 10780 - Constant Source Emissions - Determination of Gas Flow Rate and Flow Rate in Chimneys
- EPA Method 2 - Fixed Source Emissions - Determination of Gas Flow Rate and Flow Rate in Chimneys
- EPA 40 CFR 50 AppJ - Determination of PM 10 Fraction of Suspended Particulate Matter
- EPA Method 29 - Fixed Source Emissions
- TS EN 12619 - Fixed Source Emissions - Determination of Mass Concentration of Total Organic Carbon in the Gaseous State at Low Concentrations in Flue Gases
- ISO 11338-1, ISO 11338-2 - Fixed Source Emissions-Determination of Mass Concentration of Polycyclic Aromatic Hydrocarbons (PAH) in Gas and Particulate Phase
- EPA Method 13 A - Fixed Source Emissions - Determination of Total Fluorine (F) Content
- TS EN 1911 - Constant Source Emissions-Analysis of Mass Concentration of Gaseous Chlorides Defined as HCl
For Emission Measurements, you can contact Nanolab Environmental Analysis Laboratory.
